Kitchen worktops in Whitechapel

Yes. Estate and terrace kitchens are compact and usually closed off, running 2m to 2.6m along one wall, and many are set up for a large household with a full-size cooker and a second fridge in the run. New towers along the main road have developer-fitted open-plan kitchens with an island, often replaced within a few years. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

Victorian terrace, 1930s and post-war estate block and 2015 onwards high-rise apartment. Concrete panel walls bow noticeably over the length of a run, so the template picks up the real line and the back edge is cut to follow it. The carry is the constraint. That is the shape of the day.

The main road is a red route with a street market along it for most of the week, so unloading is via side turnings and a longer carry. New residential towers require a booked loading bay slot, a lift protection booking with concierge, and often a delivery window outside peak hours. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop splashbacks & upstands, in that order. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. It is two different trades on one postcode: hand-carried small pieces into old estate kitchens, and booked service lifts and island slabs in the new towers.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.