Worktop fabrication in Wimbledon

Yes. Wimbledon is on the patch, and the postcodes we work here are SW19. It is worked on our south west London run, along with the rest of Merton. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The bay at the front and the back addition at the rear were built to different standards, and the kitchen is nearly always in the weaker of the two. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Every join over a gable, clear of every cut-out. The knock-through peninsula is where the money and the risk sit, you are butting new stone against a wall the builder made good after removing a chimney breast, so template after plastering, never before.

The town centre one-way system and the bus lanes on the Broadway leave almost no legal standing time, and the residential streets either side are permit-only with short single-yellow windows. Anything going into a flat above the shops is a stair-only carry from a shared street door. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.