Worktop design and quotation in Angell Town

Yes. Angell Town is on the patch, and the postcodes we work here are SW9. It is worked on our south London run, along with the rest of Lambeth. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These are built in dense concrete, so support for a peninsula or an end panel goes in with proper anchors rather than plugs. Templating, fabrication and fitting are the same day's work whether the kitchen is five square metres or eight, so on a small kitchen they are a larger share of the total, and one slab covers the lot, which makes the material band the main lever you actually control. You see it before you commit to anything. Because the plans repeat, a template from one unit is a useful starting point, but the deck-side wall is usually 10 to 20mm out of parallel between flats, so still measure each one.

Original deck-access sections mean a horizontal walkway carry from a stair core rather than a direct approach, and the parking is in courts below the decks. Access arrangements go through the housing provider, not the resident. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.