Worktop design and quotation in Brixton Hill

Yes. Brixton Hill is on the patch, and the postcodes we work here are SW2. It is worked on our south London run, along with the rest of Lambeth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These were built with a scullery that has since been swallowed by an extension, leaving a change of floor level roughly where the run crosses. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. Kitchens in converted villas sit on suspended timber floors that flex under a stone island, so check for a supporting wall or add noggins before committing to anything freestanding.

The hill itself is the constraint, steep front paths, steps up to raised ground floors and long staircases inside converted houses. Permit parking applies and the main road has bus lanes, so the van usually sits on a side street with a climb to the door. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop replacement and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.