Worktop templating in Angell Town

Yes. Angell Town is on the patch, and the postcodes we work here are SW9. It is worked on our south London run, along with the rest of Lambeth. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. No stone is ever cut from a plan. Because the plans repeat, a template from one unit is a useful starting point, but the deck-side wall is usually 10 to 20mm out of parallel between flats, so still measure each one.

Original deck-access sections mean a horizontal walkway carry from a stair core rather than a direct approach, and the parking is in courts below the decks. Access arrangements go through the housing provider, not the resident. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.