Splashbacks and upstands in Angell Town

Yes. Angell Town is on the patch, and the postcodes we work here are SW9. It is worked on our south London run, along with the rest of Lambeth. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A maisonette puts the kitchen on one of two levels, so an internal staircase may be part of the route as well as the communal one. Dense concrete takes adhesive better than fixings, which actually suits a large bonded panel. Cut from the same slab run as the tops. Because the plans repeat, a template from one unit is a useful starting point, but the deck-side wall is usually 10 to 20mm out of parallel between flats, so still measure each one.

Original deck-access sections mean a horizontal walkway carry from a stair core rather than a direct approach, and the parking is in courts below the decks. Access arrangements go through the housing provider, not the resident. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. That is agreed at template, not on fitting day.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Same slab run as the tops.