Worktop fabrication in Avery Hill

Yes. Avery Hill is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. Settled on the drawing, cut once. A lot of like-for-like replacements over existing carcasses, check the old units are still level and sound before promising a flat finish.

Wide residential roads with verges and drives, plenty of turning room, and quiet park roads outside school run times. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.