Worktop fabrication in Mottingham

Yes. Mottingham is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Bromley. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. The bench proves it before the van moves. Galley runs this narrow leave under 900mm between opposing worktops, so we bring the pieces in on edge and set the second run before fitting the sink.

Wide estate roads with plenty of parking and short front paths, so the carry is short and flat, though many houses only have a pedestrian gate and no drive. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.