Worktop templating in Avery Hill

Yes. Avery Hill is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. Carcass heights are read individually, since legs bottoming out on concrete mean the units do not share one plane. No stone is ever cut from a plan. A lot of like-for-like replacements over existing carcasses, check the old units are still level and sound before promising a flat finish.

Wide residential roads with verges and drives, plenty of turning room, and quiet park roads outside school run times. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.