Worktop templating in Bakers Arms

Yes. Bakers Arms is on the patch, and the postcodes we work here are E10, E17. It is run from the Essex side, covering Essex & East London. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Working hours are constrained by the business underneath, so noisy work has a window rather than a day. The scribe at worktop height differs from the one at plinth level, and only the worktop line matters. No stone is ever cut from a plan. Rented and converted flats here mean a lot of like-for-like replacements around existing sinks and hobs, so the old top gets measured before it comes out.

The junction is a major bus corridor with red route sections and loading bans, so drops happen on the side streets which are permit-controlled and busy. Above-shop flats have a shared side door, a steep straight stair and no lift, so anything over about 2.2m needs jointing. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.