Worktop fabrication in Barbican

Yes. Barbican is on the patch, and the postcodes we work here are EC2Y. It is worked on our the City run, along with the rest of the Square Mile. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. These have a back door straight into the kitchen so getting pieces in is rarely the issue, but the room is small and the runs are short, which puts the sink, hob and tap cut-outs close together on a single length of stone. Settled on the drawing, cut once. Do a full dry run of the route from car park lift to flat door before ordering, because the Barbican's walk-in is longer and more awkward than any staircase in the City.

There is no vehicle access to the podium at all - you park in one of the estate car parks below, then use a car park lift and walk the highwalks and internal corridors, which can be several hundred metres with multiple fire doors and level changes. Lift cars in the residential cores are small with low ceilings, so anything over about 2.2m has to be assessed against the specific core before you cut. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. Final appliance positions and the actual sink and hob need to be settled before machining, because on a run this short a few centimetres of movement decides whether the piece can be cut in one. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.