Worktop templating in Bayswater

Yes. Bayswater is on the patch, and the postcodes we work here are W2. It is worked on our central London run, along with the rest of Westminster. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. High-turnover rental flats want the cheapest workable spec, so keep it to a plain square-edge quartz with a matching upstand - budget dictates the material here more than taste does.

Almost all flats are conversions with a shared front door, a wide but long communal stair, and no lift above the second floor. Parking is metered and permanently full, and the hotel traffic on the main roads blocks the kerb all day. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where the owner is not local, the decisions happen remotely, so photographs and a clear itemised drawing carry more weight than a showroom visit ever would. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.