Worktop fabrication in Belsize Park

Yes. Belsize Park is on the patch, and the postcodes we work here are NW3. It is worked on our central and north London run, along with the rest of Camden. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. Every join over a gable, clear of every cut-out. Conversion partitions are stud rather than brick, so check the fixing before cantilevering a peninsula off one, and expect the ceiling drops to force a lower splashback height than the client asked for.

CPZ enforced Monday to Friday with permit-only bays on the hill streets, and residents' parking around Haverstock Hill is effectively full all day. Communal front doors, no lifts in the villa conversions, and half-landing turns on the original staircases mean the tightest measurement is usually the return on the first-floor stair. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Dot-and-dab plasterboard sounds solid and is hollow behind, so anything fixed through it has to hit a dab or a batten rather than a void. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.