Kitchen worktops in Belsize Park

Yes. Mostly big villas cut into flats, so the kitchen is often a converted reception or a rear half-landing room with a high ceiling and only one genuinely usable wall. Garden flats take a proper 3.5m run plus a peninsula onto the rear, but plenty of the upper flats are five-sided rooms created by conversion partitions with no square corner to work from. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Italianate stucco villa, large conversion flat, red-brick mansion block and post-war infill. Original walls are thick, lime-plastered and rarely straight, which makes dry-laying and scribing the bulk of the fitting day. Access through the property is usually the simplest of any archetype, with wide doors and generous rooms, so we can often carry a full-length piece straight in without a planned join. That is the shape of the day.

CPZ enforced Monday to Friday with permit-only bays on the hill streets, and residents' parking around Haverstock Hill is effectively full all day. Communal front doors, no lifts in the villa conversions, and half-landing turns on the original staircases mean the tightest measurement is usually the return on the first-floor stair. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop replacement, worktop templating and worktop installation, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Conversion partitions are stud rather than brick, so check the fixing before cantilevering a peninsula off one, and expect the ceiling drops to force a lower splashback height than the client asked for.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.