Worktop templating in Bethnal Green

Yes. Bethnal Green is on the patch, and the postcodes we work here are E2. It is run from the Essex side, covering Essex & East London. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. No stone is ever cut from a plan. Half the terraces here have been through two or three refits and the rear walls are out of square by 15-20mm, so nothing gets cut off drawings without a physical template.

Terraced streets are permit-only Monday to Friday with no forecourts, and Columbia Road and its feeder streets are effectively closed by the Sunday flower market, so schedule around it. The 1890s tenement blocks have winding stone stairs, no lift and half-landing turns that a full 3m piece will not pass, so plan for a joint or a hoist. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop installation. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.