Splashbacks and upstands in Bow Common

Yes. Bow Common is on the patch, and the postcodes we work here are E3, E14. It is worked on our east London run, along with the rest of Tower Hamlets. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An infill house is built to modern standards on an old plot, so the room is square even though the site around it is not. The plasterboard is flat enough for a full-height panel; it is the socket positions that cause the trouble. The wall makes that decision, not the brochure. Boilers and gas meters are frequently mounted in the run, so cut-outs and clearances need agreeing on site before anything is fabricated.

Wide estate roads and open parking courts make the physical unload easy, but bollards and locked gates between courts mean the shortest route on a map often is not open. The 1980s infill houses have a straight run from front door to kitchen, which is a rare thing round here. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. Any socket you intend to move must be moved and re-plastered before templating, because a cut-out in the wrong place means a new piece of stone. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops.