Worktop templating in Bow

Yes. Bow is on the patch, and the postcodes we work here are E3. It is worked on our east London run, along with the rest of Tower Hamlets. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deep original skirting is often left in behind the units, standing them off the wall, so the back edge of the stone is plotted where the carcasses actually sit. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. The converted mill flats have genuinely long uninterrupted runs, so you are into slab-yield planning and matched joints rather than the usual terrace offcut job.

The market days on the main shopping street close the loading options completely, and side streets have permit bays with dispensation needed from the borough. Factory conversions have wide industrial stair cores and a goods lift, which is the easiest access in the area, but the flats themselves have long internal corridors with tight turns at the kitchen door. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.