Worktop templating in Bromley-by-Bow

Yes. Bromley-by-Bow is on the patch, and the postcodes we work here are E3. It is worked on our east London run, along with the rest of Tower Hamlets. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A maisonette puts the kitchen on one of two levels, so an internal staircase may be part of the route as well as the communal one. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. Two to three hours, once the units are in. Lift depth decides the job here, so measure the car before quoting a single-piece top for anything above the second floor.

The area is cut in two by a dual carriageway with red route restrictions on the approach, so unloading has to happen inside the estate roads rather than the main road. Estate parking is permit-controlled and the older blocks have a single small passenger lift, often around 1.1m deep, which caps piece length. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.