Worktop replacement in Bromley-by-Bow

Yes. Bromley-by-Bow is on the patch, and the postcodes we work here are E3. It is worked on our east London run, along with the rest of Tower Hamlets. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. It is a full day at the kerb, not a delivery. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A maisonette puts the kitchen on one of two levels, so an internal staircase may be part of the route as well as the communal one. Plaster bonded straight onto concrete comes away with the bottom course of tiles, leaving a band behind the upstand. What is under the old top is the real question. Lift depth decides the job here, so measure the car before quoting a single-piece top for anything above the second floor.

The area is cut in two by a dual carriageway with red route restrictions on the approach, so unloading has to happen inside the estate roads rather than the main road. Estate parking is permit-controlled and the older blocks have a single small passenger lift, often around 1.1m deep, which caps piece length. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. We would rather find it at template than on the morning, which is why the templater looks behind the units. It is the usual surprise, and it is a known one. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Sound carcasses are the condition.