Worktop installation in Brompton

Yes. Brompton is on the patch, and the postcodes we work here are SW3. It is worked on our west London run, along with the rest of Kensington and Chelsea. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The structure below is commercial, so the floor is often timber over a shop ceiling and the load path under an island is worth thinking about. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. That is the shape of the day. Scribing is the skill here - decades of boxed-in services mean almost nothing behind a base unit is actually straight or plumb.

The main road is a red route with no stopping in the day, so unloading happens on the mews and side streets and the carry-in is on foot through gardens or a shared side passage. Flats above shops are reached by a single narrow street door and a straight steep stair with a hard 90 at the top, which is the piece-length limiter. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. We walk the route with a tape and protect it end to end before the first piece is lifted. None of it is worked out on the doorstep.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop replacement and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.