Worktop templating in Brompton

Yes. Brompton is on the patch, and the postcodes we work here are SW3. It is run from the New Malden side, covering South West London & Surrey. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The structure below is commercial, so the floor is often timber over a shop ceiling and the load path under an island is worth thinking about. The scribe at worktop height differs from the one at plinth level, and only the worktop line matters. Recorded as it is, not as it was drawn. Scribing is the skill here - decades of boxed-in services mean almost nothing behind a base unit is actually straight or plumb.

The main road is a red route with no stopping in the day, so unloading happens on the mews and side streets and the carry-in is on foot through gardens or a shared side passage. Flats above shops are reached by a single narrow street door and a straight steep stair with a hard 90 at the top, which is the piece-length limiter. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop splashbacks & upstands. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.