Kitchen worktops in Bushey Mead

Yes. Uniform interwar semis with rear kitchens that owners typically extend by two or three metres to create a kitchen-diner, keeping cabinetry on one wall and putting a dining table where the garden door used to be. Compact islands of around 1.8m appear where the extension is wide enough. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s semi, Interwar terrace and 1970s infill house. The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day.

Wide residential roads with no controlled parking make this one of the easier areas for van access in the borough. The limiting factor is usually the side alley between semis, which narrows at the gate post. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop templating, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. Because the houses are near-identical, sizes repeat, but never assume it, the extension depths vary by a metre either way between neighbours.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Carcasses have to be sound first. Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.