Kitchen worktops in Cannon Hill

Yes. Houses backing onto the common have kitchens reorientated to face the green, often with a peninsula under a rear window rather than a full extension. The 1960s low-rise blocks have compact fitted kitchens where a single 2.4m run and a return is the whole job. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

1930s semi, 1960s low-rise flat and Postwar detached. Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. Access is generally through the front door and a short straight hall into the kitchen, which is a good deal kinder than a Victorian terrace, though rear access through a back garden or shared path is often the better route if it exists. Walked, measured, protected, then lifted.

Roads bordering the common are quiet but have limited turning space and grass verges that a loaded van will sink into after rain. Flats in the low-rise blocks are reached by external stairs with an open landing, which makes wind a genuine handling issue with a slab on edge. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. In the flats the window sill often sits lower than the worktop line, so a sill-height check has to happen before the sink run is cut.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.