Worktop installation in Cannon Hill

Yes. Cannon Hill is on the patch, and the postcodes we work here are SW20. It is worked on our south west London run, along with the rest of Merton. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. Access is generally through the front door and a short straight hall into the kitchen, which is a good deal kinder than a Victorian terrace, though rear access through a back garden or shared path is often the better route if it exists. The slow parts are slow for a reason. In the flats the window sill often sits lower than the worktop line, so a sill-height check has to happen before the sink run is cut.

Roads bordering the common are quiet but have limited turning space and grass verges that a loaded van will sink into after rain. Flats in the low-rise blocks are reached by external stairs with an open landing, which makes wind a genuine handling issue with a slab on edge. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.