Worktop installation in Wimbledon Chase

Yes. Wimbledon Chase is on the patch, and the postcodes we work here are SW20, SW19. It is worked on our south west London run, along with the rest of Merton. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Bungalow kitchens are frequently extended into the rear or opened into the roof space, so the room is part original and part new build. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. Walked, measured, protected, then lifted. Bungalow ceilings are low, which means tall wall units come down close to the top, check hob clearance and upstand height before cutting the splashback panel.

Driveways and dropped kerbs are common so the van gets close to the door, and single-storey properties mean the carry is level from van to room. The constraint is usually a low porch canopy or a narrow front door reveal rather than stairs. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop replacement. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.