Worktop installation in Bushey Mead

Yes. Bushey Mead is on the patch, and the postcodes we work here are SW20. It is worked on our south west London run, along with the rest of Merton. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day. Because the houses are near-identical, sizes repeat, but never assume it, the extension depths vary by a metre either way between neighbours.

Wide residential roads with no controlled parking make this one of the easier areas for van access in the borough. The limiting factor is usually the side alley between semis, which narrows at the gate post. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop templating. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.