Worktop fabrication in Bushey Mead

Yes. Bushey Mead is on the patch, and the postcodes we work here are SW20. It is worked on our south west London run, along with the rest of Merton. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. Most of these have a side passage and a back door, so a full-length piece can usually reach the kitchen without being cut down, and the piece sizing is driven by the slab rather than the route. The bench proves it before the van moves. Because the houses are near-identical, sizes repeat, but never assume it, the extension depths vary by a metre either way between neighbours.

Wide residential roads with no controlled parking make this one of the easier areas for van access in the borough. The limiting factor is usually the side alley between semis, which narrows at the gate post. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.