Worktop design and quotation in Cannon Hill

Yes. Cannon Hill is on the patch, and the postcodes we work here are SW20. It is worked on our south west London run, along with the rest of Merton. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. Runs are short, joins are few and the biggest single question is whether we can go in through the back, a rear door straight from the garden into the kitchen usually lets us fit long pieces whole, whereas a mid-terrace with no side gate means everything comes through the front and may need splitting. That is what the itemised lines are for. In the flats the window sill often sits lower than the worktop line, so a sill-height check has to happen before the sink run is cut.

Roads bordering the common are quiet but have limited turning space and grass verges that a loaded van will sink into after rain. Flats in the low-rise blocks are reached by external stairs with an open landing, which makes wind a genuine handling issue with a slab on edge. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.