Worktop fabrication in Cannon Hill

Yes. Cannon Hill is on the patch, and the postcodes we work here are SW20. It is worked on our south west London run, along with the rest of Merton. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Post-war terraces have a short straight hall to the kitchen, which is a good deal kinder than the houses they replaced. These have a back door straight into the kitchen so getting pieces in is rarely the issue, but the room is small and the runs are short, which puts the sink, hob and tap cut-outs close together on a single length of stone. The bench proves it before the van moves. In the flats the window sill often sits lower than the worktop line, so a sill-height check has to happen before the sink run is cut.

Roads bordering the common are quiet but have limited turning space and grass verges that a loaded van will sink into after rain. Flats in the low-rise blocks are reached by external stairs with an open landing, which makes wind a genuine handling issue with a slab on edge. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. Final appliance positions and the actual sink and hob need to be settled before machining, because on a run this short a few centimetres of movement decides whether the piece can be cut in one. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.