Worktop fabrication in Canning Town

Yes. Canning Town is on the patch, and the postcodes we work here are E16. It is worked on our east London run, along with the rest of Newham. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. Every join over a gable, clear of every cut-out. Different phases of the same regeneration scheme have different lift sizes, so confirm the block, not just the postcode, before promising a single-piece top.

The area is carved up by flyovers, the tunnel approach and red routes, so the practical unloading point is often inside an estate or a development service yard rather than the nearest road. New blocks require the managing agent to sign off a delivery slot, and lift dimensions vary a lot between phases of the same development. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.