Splashbacks and upstands in Canning Town

Yes. Canning Town is on the patch, and the postcodes we work here are E16. It is worked on our east London run, along with the rest of Newham. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. The rear kitchen wall in ex-council flats and maisonettes is commonly dense in-situ concrete or blockwork with a thin skim, which means mechanical fixings are hard work and the splashback is held on adhesive rather than screwed. The wall makes that decision, not the brochure. Different phases of the same regeneration scheme have different lift sizes, so confirm the block, not just the postcode, before promising a single-piece top.

The area is carved up by flyovers, the tunnel approach and red routes, so the practical unloading point is often inside an estate or a development service yard rather than the nearest road. New blocks require the managing agent to sign off a delivery slot, and lift dimensions vary a lot between phases of the same development. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after.