Worktop replacement in Canning Town

Yes. Canning Town is on the patch, and the postcodes we work here are E16. It is worked on our east London run, along with the rest of Newham. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is nearly always a boxed service duct or a stopcock cupboard in one corner, and it eats into the usable depth of the run. Ex-council flats and maisonettes are built in dense concrete and blockwork, so anything that has to be fixed back, such as brackets under a peninsula or support for an end panel, goes in with proper anchors and an SDS rather than plasterboard fixings. What is under the old top is the real question. Different phases of the same regeneration scheme have different lift sizes, so confirm the block, not just the postcode, before promising a single-piece top.

The area is carved up by flyovers, the tunnel approach and red routes, so the practical unloading point is often inside an estate or a development service yard rather than the nearest road. New blocks require the managing agent to sign off a delivery slot, and lift dimensions vary a lot between phases of the same development. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Old tops out in the morning, new stone down and sealed the same afternoon. A plumber either side of us. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. We would rather find it at template than on the morning, which is why the templater looks behind the units. Found at template, not on fit day. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us.