Kitchen worktops in Canning Town

Yes. New regeneration blocks have compact open-plan kitchens with a 2.4m to 3m run and a tall appliance stack, no island, and a balcony door at one end. Older estate flats keep a separate kitchen of around 2.2m with a boiler cupboard eating the corner. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

post-war council estate, 1980s low-rise and 2010s onwards regeneration apartment block. Low-rise blocks are three or four storeys with a single stair and no lift, so pieces go up on edge and the half-landing sets the maximum length. The rear kitchen wall in ex-council flats and maisonettes is commonly dense in-situ concrete or blockwork with a thin skim, which means mechanical fixings are hard work and the splashback is held on adhesive rather than screwed. Cut from the same slab run as the tops.

The area is carved up by flyovers, the tunnel approach and red routes, so the practical unloading point is often inside an estate or a development service yard rather than the nearest road. New blocks require the managing agent to sign off a delivery slot, and lift dimensions vary a lot between phases of the same development. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Different phases of the same regeneration scheme have different lift sizes, so confirm the block, not just the postcode, before promising a single-piece top.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.