Worktop templating in Cheam

Yes. Cheam is on the patch, and the postcodes we work here are SM2, SM3. It is run from the New Malden side, covering South West London & Surrey. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear room is generous with a chimney breast in one corner, so the run gains a return and two scribed ends whatever the plan drew. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Recorded as it is, not as it was drawn. This is where the big single-piece islands go, so slab selection and vein matching across the island and the tall-unit return is discussed with the client before anything is cut.

Wide roads with generous in-and-out drives and space to unload off the highway, though the village conservation area itself is tight with loading restrictions near the parade. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.