Worktop templating in Sutton

Yes. Sutton is on the patch, and the postcodes we work here are SM1, SM2. It is run from the New Malden side, covering South West London & Surrey. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. The pedestrian zone hours dictate everything here, so town-centre fits get booked for early morning and the van has to be clear before the restriction starts.

Pedestrianised High Street with strict vehicle access hours, controlled parking on the surrounding streets, and apartment blocks with booked lifts and loading bays. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.