Worktop fabrication in Cheapside

Yes. Cheapside is on the patch, and the postcodes we work here are EC2V. It is worked on our the City run, along with the rest of the Square Mile. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. Overhangs on these breakfast bars need steel flat bar, not faith - 30mm quartz unsupported past about 300mm will crack at the sink corner sooner or later.

Cheapside itself has bus lanes and daytime loading restrictions, and the residential entrances are usually a discreet side door off a neighbouring lane rather than on the main frontage. Retail servicing takes priority in the shared basement bays, so residential deliveries get an off-peak slot, generally mid-morning or after the shops shut. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.