Kitchen worktops in Cheapside

Yes. Residential units above the Cheapside retail frontage are modern and tightly planned, with a galley or L of 2.8-3.4m and a breakfast bar overhang of 250-300mm that needs proper bracketry rather than relying on the stone. New stock came with composite tops that owners are now upgrading to quartz, keeping the existing undermount sink position and tap holes. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

modern apartment above retail, postwar block with upper-floor flats, office conversion and mixed-use development. A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn.

Cheapside itself has bus lanes and daytime loading restrictions, and the residential entrances are usually a discreet side door off a neighbouring lane rather than on the main frontage. Retail servicing takes priority in the shared basement bays, so residential deliveries get an off-peak slot, generally mid-morning or after the shops shut. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Worktop replacement, worktop installation and worktop templating, in that order. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Overhangs on these breakfast bars need steel flat bar, not faith - 30mm quartz unsupported past about 300mm will crack at the sink corner sooner or later.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.