Kitchen worktops in St Paul's

Yes. The handful of residential flats here sit above shops and offices in postwar and modern blocks, so kitchens are compact open-plan arrangements of 2.6-3.2m with an integrated appliance stack and no room for an island. Ceiling voids carry a lot of services, which means bulkheads over the run and wall cupboards that stop short - stone upstands and a full-height splashback fill the gap neatly. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

postwar reconstruction block with flats above, modern apartment over retail, 1960s-80s commercial building converted to residential and small conversion flat. Dot-and-dab plasterboard bellies at a taped internal angle, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. The room itself is the easy part: walls are plumb, corners are square and the floor is flat, so scribes are minimal and joins can be tight. Units kept, surface changed, one day.

The immediate cathedral surroundings are pedestrianised with bollards and stepped paving, so the van stops on a permitted street and the last 100m or more is on foot across paving that is unkind to a trolley. Service access to residential floors is usually shared with the commercial tenants and restricted to outside their delivery hours. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Stepped and setted paving around the cathedral will jar a trolley badly, so carry the last stretch on a frame rather than wheeling it over the flags.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.