Worktop templating in Coldharbour

Yes. Coldharbour is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. Recorded as it is, not as it was drawn. Those stair turns on the maisonettes cap the piece length, measure the turn, not just the doorway.

Estate layout with parking courts and rear footpaths, and several maisonette blocks reached by an external stair with a tight turn at the top. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.