Bathroom worktops and vanity tops in Edgware

Yes. Edgware is on the patch, and the postcodes we work here are HA8. It is worked on our north London run, along with the rest of Barnet. A shared drive is only useful if the neighbour is not the one parked behind the van, so we ask which side the standing belongs to before the date is set. A vanity fit is a short visit with one or two pieces in it, so the van stands only for as long as it takes to walk them in. Ordered with the kitchen, the bathroom costs no extra journey. Everything that involves you happens in your kitchen, so there is nothing to visit and nothing to collect.

A side door into a lobby with a cloakroom off it is the standard arrangement, so there is a second way in that misses the hall altogether. The original bathroom in these houses is the small room over the hall, and a vanity in it is short, shallow and hard against a wall at each end, so both ends are scribed and there is no tolerance left between them. A bathroom over a kitchen has its waste run already decided. Old breasts carry a bulge low down where the original opening was closed up, and the units stand off it before the stone is measured at all. Bathrooms carry the same problems in a smaller room, and a smaller room leaves a vanity nowhere to absorb them. The top follows the unit, and the unit follows a level.

The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. A vanity is the one piece of stone that route will not usually defeat, because a top cut to a standard unit depth weighs what one person can manage. Nothing is stood on edge once the tap holes are drilled. Drives with a dropped kerb and a tight turn-in take a long van at an angle, and that angle decides which side the tail lift can work from. Where the van cannot wait, the top, the shelves and the adhesive all come in on the first trip and the van goes. A bathroom return visit is planned around the street, not the diary.

Not to any real extent, and it would be easy to imply it was. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop fabrication. It describes the kitchens on this patch, not the work that goes into them. Same quoting, same cutting, same fitting as anywhere else on the patch. An open-plan extension puts the worktop in the middle of the living space, so it is looked at from the sofa as well as worked on. Where several bathrooms are done in one building the tops come off one slab run, because two greys from two batches sit badly on adjoining floors. The bathroom is decided late and the offcut has usually gone. Extension budgets are usually well spent by the time the worktop is ordered, which is where the choice between quartz and a thinner sintered stone actually gets made. A house divided into flats needs a vanity for each of them, and small repeated pieces are the one case where buying a whole slab makes sense. Batched vanity tops are templated in one visit.

Where the aisle is too tight the usual answer is a reduced-depth top on one side, and a 500mm run is a different cut, a different sink and a different drainer to a 600mm one. That shape decides what is left on the slab when the kitchen has been cut, and what is left on the slab is where most vanity tops come from. A slab bought for a bathroom alone is mostly unused, and priced so. Stone is £110 to £550 per square metre supply only, and the templating, the fabrication and the fitting each carry their own line.

Two alcove pieces will not swap over however similar they look, so they are marked left and right at the bench and stay that way to the van. A vanity has no depth to lose, so where a kitchen run would take a ten millimetre scribe without noticing, a shallow top cannot spare it. A shelf in a shower niche is scribed on three sides. Settle the tiling height and the basin model first, and let us know whether the unit is standing on the floor or hanging off the wall. Someone who expects to still be there in ten years asks different questions: how a honed finish marks, what a sealer does and does not do, and whether a chip by the sink can be repaired in place. A let bathroom wants quartz for the same reason a let kitchen does: nothing to seal, and nothing an incoming tenant has to be briefed on. A specification repeated across flats is drawn once.

Slabs come in finite sizes, so a long run needs a join whatever the room looks like. What you get is a line rather than a step, because the pieces are levelled to each other first. A mitred join at a corner is a different job from a butt join along a run, and they are not priced the same. Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A bathroom ordered with the kitchen is taken from the same slab run, so the two rooms match rather than nearly match. The bathroom pieces are labelled on the nest before the saw runs.

Taking the old tops away is a line rather than an assumption, so it comes off if you do not want it. Cut-outs, edge profile and join count are itemised, so taking one out removes a line rather than starting an argument. Ask for the lines rather than the total. One number for a kitchen tells you nothing you can check. A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The boxed soil stack in the corner is the usual version of it upstairs, and a top that notches round one loses depth exactly where the basin wanted it. A vanity has no depth to give away to a scribe.

Old tops are screwed or glued from underneath, so the drawer boxes come out before the worktop does. If you want the old top kept for a garage or a utility, say so and it stays on site. Old laminate is light and awkward rather than heavy, so it is usually the easier half of the day. Where the drive is too short for the van the back end overhangs the footway, and a footway is a route people are using rather than spare space. A bathroom booked on its own rarely fills a day, so it can be put into whichever part of the day the street is easiest. Tap holes are drilled at the works, so nothing keeps the van waiting.

Doorways, the newel post and the handrail usually take the room away, rather than the stairs themselves. If a piece cannot be got in at all, we say so at the template rather than on the day. A join forced by the route still sits over a gable, so it is no poorer a join for that. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. The exception is a double vanity, which is a kitchen length in bathroom width and behaves like a worktop from the tail lift onwards. A double vanity is a worktop as far as the carry is concerned.