Worktop templating in Edgware

Yes. Edgware is on the patch, and the postcodes we work here are HA8. It is worked on our north London run, along with the rest of Barnet. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. The sill height over the sink is settled on site, because there is often less clearance than an upstand is tall. Two to three hours, once the units are in. Two sinks and two hobs in one run leaves very little solid material between cut-outs, so the piece needs rodding or a repositioned joint to survive transport.

Wide 1930s roads with driveways and clear side access on most houses, though a lot of side alleys have been filled by side extensions. Around the station and the shopping centre, loading is restricted and multi-storey height barriers rule out taller vans. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.