Worktop templating in Stanmore

Yes. Stanmore is on the patch, and the postcodes we work here are HA7. It is worked on our north west London run, along with the rest of Harrow. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. The sill height over the sink is settled on site, because there is often less clearance than an upstand is tall. Two to three hours, once the units are in. Separate meat and dairy runs mean planning two identical worktops from the same batch so the colour matches across the room, and that is a slab reservation decision, not a fitting decision.

Long gravel or block-paved driveways with gates and often a turning circle, so vehicles get very close, but the internal carry from the front door to the rear kitchen can be 15m or more with a hallway turn. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.