Worktop templating in Enfield Wash

Yes. Enfield Wash is on the patch, and the postcodes we work here are EN3. It is worked on our north London run, along with the rest of Enfield. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. Runs commonly finish at a doorway, and the architrave and skirting stand proud of the plaster, so the end of the top is notched or stopped on the drawing. Two to three hours, once the units are in. Old flat-roof extensions have thrown their base units out of level - shim and re-level the carcasses before templating or the quartz sits on three points.

Wide residential streets off Ordnance Road with driveways or a hardstanding on most plots, so the van gets close. The catch is a side gate and a narrow passage down the side of the house if the kitchen is at the back. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.