Worktop design and quotation in Figges Marsh

Yes. Figges Marsh is on the patch, and the postcodes we work here are CR4. It is worked on our south west London run, along with the rest of Merton. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The stair from the street is narrow with a tight turn at the top, which caps piece length well below anything the run itself needs. Runs are short, joins are few and the biggest single question is whether we can go in through the back, a rear door straight from the garden into the kitchen usually lets us fit long pieces whole, whereas a mid-terrace with no side gate means everything comes through the front and may need splitting. Priced from the building, not from a rate card. Steep single-flight stairs to above-shop flats mean anything over 2.4m has to be cut down first, measure the stairwell before deciding where the joint goes.

The London Road frontage is a busy bus corridor with red-route style restrictions in places and no realistic standing, so deliveries go in early. Above-shop flats are entered through a shared street door with a straight steep stair and no turning space at the top. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.