Worktop templating in Figges Marsh

Yes. Figges Marsh is on the patch, and the postcodes we work here are CR4. It is worked on our south west London run, along with the rest of Merton. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The stair from the street is narrow with a tight turn at the top, which caps piece length well below anything the run itself needs. Post-war terraces have a fairly shallow, standardised kitchen, and the walls tend to lean rather than bow, so the scribe at worktop height is different from the one at plinth level - the template only cares about the line where the stone will land. Recorded as it is, not as it was drawn. Steep single-flight stairs to above-shop flats mean anything over 2.4m has to be cut down first, measure the stairwell before deciding where the joint goes.

The London Road frontage is a busy bus corridor with red-route style restrictions in places and no realistic standing, so deliveries go in early. Above-shop flats are entered through a shared street door with a straight steep stair and no turning space at the top. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.