Worktop fabrication in Gloucester Road

Yes. Gloucester Road is on the patch, and the postcodes we work here are SW7. It is worked on our west London run, along with the rest of Kensington and Chelsea. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

External walls are thick and the run under the window sits in a deep reveal that has to be templated rather than assumed square. Ceilings are high and external walls are thick, so the run under the window sits in a deep reveal and the back edge has to be templated to the reveal rather than assumed square. The bench proves it before the van moves. Old service lifts are the hard limit on this street - if the car will not take it, the joint gets designed around the lift, not around the kitchen.

Blocks here have a front porter's desk and a separate tradesman's entrance round the side, and materials go in the service lift only, with protective blankets on the walls. The lifts are old, often around 1000mm by 1300mm internally with a low car ceiling, which caps a stood-on-edge slab at roughly 2.2-2.4m unless the stairs are used instead. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. Access arrangements and the porter's permitted hours need confirming before we cut, because the agreed piece size is what the nesting is built around. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.