Kitchen worktops in Golden Lane

Yes. The Golden Lane flats were built small and efficient, and the kitchens are the smallest residential kitchens you will template in the City - often a single run of 1.8-2.4m with 500-550mm deep units rather than the modern 600mm. Original built-in features and the listed status mean the job is usually a precise like-for-like replacement, sometimes on non-standard depths that have to be cut rather than assumed. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

1950s listed estate block, maisonette with double-height living room, compact one-bedroom flat and listed crescent block. Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. Recorded as it is, not as it was drawn.

Deliveries come off narrow surrounding streets with almost no loading provision, then through a courtyard on foot to a single lift per core - and the lift cars are genuinely small, so a slab may need to go up the stairs instead. The estate is listed, so nothing gets propped, taped or fixed to walls and finishes along the route. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Measure the unit depth rather than assuming 600mm - a lot of these kitchens are shallower, and a standard-depth top will foul the opposite wall in a 1.8m room.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.