Splashbacks and upstands in Golden Lane

Yes. Golden Lane is on the patch, and the postcodes we work here are EC1Y. It is worked on our the City run, along with the rest of the Square Mile. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Dense concrete takes adhesive better than fixings, which actually suits a large bonded panel. The wall makes that decision, not the brochure. Measure the unit depth rather than assuming 600mm - a lot of these kitchens are shallower, and a standard-depth top will foul the opposite wall in a 1.8m room.

Deliveries come off narrow surrounding streets with almost no loading provision, then through a courtyard on foot to a single lift per core - and the lift cars are genuinely small, so a slab may need to go up the stairs instead. The estate is listed, so nothing gets propped, taped or fixed to walls and finishes along the route. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. Joint positions follow from that.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. Make the wall good first, or accept the detail. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.