Worktop replacement in Goodmayes

Yes. Goodmayes is on the patch, and the postcodes we work here are IG3. It is worked on our east London run, along with the rest of Redbridge. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deep original skirting is often left in behind the units, standing them off the wall, so the back edge of the stone is plotted where the carcasses actually sit. What the old top has been hiding is usually a floor that settled towards the back and units that were never fixed back to the wall. What is under the old top is the real question. Range cookers dominate here and the cut-outs sit close to end walls, so we check the actual cooker width on site instead of working off the plan measurement.

Mixed: terraces on the south side with kerbside-only unloading, and 1930s roads to the north where most houses have a crossover and a hardstanding to park on. Rear extensions usually leave a usable side alley of around a metre. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop templating. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Sound carcasses are the condition.