Kitchen worktops in Hanger Hill

Yes. Garden estate flats with small original kitchens and a management company that has views on layout changes, giving two-wall runs under 3m, alongside the larger mock-Tudor houses taking full remodels. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

1930s Hanger Hill Garden Estate flat, mock-Tudor semi and detached and interwar apartment block. These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Long perimeter runs and an island mean level has to hold across the whole room, so the templater sets a single datum and works every run and the island off it rather than levelling each wall in isolation. Recorded as it is, not as it was drawn.

The Hanger Lane gyratory and the A40 dominate the approach. The garden estate has communal courts, controlled parking and low-rise blocks with no lifts. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop replacement, worktop installation and worktop templating, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. Those walk-up blocks have tight stair turns with a low soffit, so anything over 2.4m has to be jointed simply to get it up to the flat.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.